Amana Home Laundry Automatic Washer Manual do Utilizador

Installation lnstruc.tionsHome Laundry Automatic WashersKEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. (If the washer changesownership, be sure this ma

Add Water to the WasherTo prevent damage to pump, do not run washer beforeadding at least on; quart water to the tub. If the washer isrun before any w

Electrical Requirements w n n(120 Volt, 60 Hertz with 3-Prong Grounding Plug)NOTE: The wiring diagram is located in the controlhood..AWARNINGTo reduce

WARNH+dGUnder certain conditions, hydrogen gas maybe produced in a hot water system that hasnot been used for two weeks or more.HYDROGEN GAS IS EXPLOS

1438774

38774

Installerheck q q pFast Track for Installing the Washer-(Refer to the manual for more detailed information)0CHECK./;a\/Iti?--,Y,b ;\ ,/W373tEOCWashtub

1.,. , .->_.,_Replticetient Parts-<. . . . . ..*...*...*...*...*...*...*.*...*...*.*...~...2Table ofRoughing In

Roughing In Dimensions q E n*WITH LEVELING LEGS TURNED INTO BASEBefore You Start n n RElectricalFor most installations, the basic tools vou will need

Installing the. Washer n n nStep 1:Remove the Shipping Brace andShipping PlugNOTE: Install drver before washer. This allows roomfor attaching exhkst d

Step 3:Connect Water Inlet IHosesXOTE: Refer t.o Section on Water Szqq~lyRequirements before connecting water inlet hoses.Remove the two screene.d fil

Step 4:Connect Drain Hose to DrainReceptacleRemove the drain hose from its shipping position on therear of the washer by unhooking the hose. from ther

High Standpipe Installation:Place the adapter into the standpipe. Remove the beadedtie-down strap from accessories bag and place aroundstandpipe and d

Sink Installation:For this type of installation, use the beaded tie-down strap(supplied in accessories bag), or use a large wire tie(available from yo

Step 5:Position and Level the WasherPlace rubber feet on all four leveling legs.‘Place washer in position on a clean, dry, and reasonablyfirm floor. I